BMBMC - PDL 729

Product Identification

Product ID:PDL 729
MSDS Date:11/08/1990
FSC:8030
NIIN:00N025401
MSDS Number: BMBMC

Responsible Party
POLYMER DEVELOPMENT LABS INC
212 W TAFT AVE
ORANGE, CA 92665
US

Emergency Phone: 714-921-2300

Info Phone: 714-921-2300

Cage: 1N060

Contractor
POLYMER DEVELOPMENT LABORATORIES INC
ORANGE, CA 92665-4220 US

Telephone: 714-921-2300

Cage: 1N060

Ingredients

NO INGREDIENT FOR THIS FORMULATION_INGREDIENT

Hazards

LD50 LC50 Mixture:LD50: (ORAL, RATS) >5000 MG/KG
Routes of Entry: Inhalation:YES Skin:YES Ingestion:NO
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:INHAL: MAY CAUSE IRRITATION TO THROAT
& RESPIRATORY PASSAGES BUT AT ROOM TEMP, VAPOR INHALATION IS NOT
CONSIDERED HAZARDOUS. SKIN: THIS PROD CONTAINS AMINE CATALYST &
WILL CAUSE IRRIT AFTER PRLNG CONT . SOME INDIVIDUALS MAY BE MORE
SENSITIVE TO EXPOSURE. INGEST: THIS IS NOT CONSIDERED A COMMON
OCCUP (EFTS OF OVEREXP)
Explanation of Carcinogenicity:NOT RELEVANT
Effects of Overexposure:HLTH HAZ: ROUTE OF EXPOSURE, AND NO OBSERVABLE
EFFECTS HAVE BEEN DEMONSTRATED.
Medical Cond Aggravated by Exposure:NONE SPECIFIED BY MANUFACTURER.

First Aid

First Aid:EYES: FLUSH W/CLEAN/LUKE-WARM H*2O AT LOW PRESS FOR AT LST 15
MIN, OCCAS LIFTING EYELIDS. CONSULT MD IMMED. SKIN: REMOVE CONTAMD
CLTHG. WASH EXPOSED AREA W/WARM SOAPY H*2O THORO. CONTAMD CLTHG
SHLD BE PROPERLY WASHED BEFORE REUSING. INHAL:NOT CONSIDERED HAZ
IN AN INDUS SITUATION. REMOVE TO FRESH AIR. SUPPORT BRTHG (GIVE
O*2/ARTF RESP) . INGEST: INDUCE VOMIT. NEVER GIVE ANYTHING (SUPP
DATA)

Fire Fighting

Flash Point Method:PMCC
Flash Point:248F,120C
Extinguishing Media:DRY CHEM EXTING SUCH AS MONOAMMONIUM PHOSPHATE/
POTASSIUM SULFATE/POTASSIUM CHLORIDE. ADDITIONALLY, CO*2, (SUPP
DATA)
Fire Fighting Procedures:DO NOT DIRECT SOLID WATER STREAM/FOAM INTO
HOT/ BURNING POOLS; THIS MAY CAUSE FROTHING & INCREASE FIRE
INTENSITY. USE NIOSH/MSHA APPRVD SCBA & FULL (SUPP DATA)
Unusual Fire/Explosion Hazard:NONE.

Accidental Release

Spill Release Procedures:CONTAIN SPILLED MATL & THEN COVER W/A LOOSE,
ABSORBANT MATL SUCH AS OILDRY, VERMICULITE, SAWDUST OR FULLER'S
EARTH. SHOVEL WASTE MATL INTO PROPER WASTE CONTRS. WASH CONTAMD
AREAS W/HOT SOAPY WATER THO ROUGHLY. VENTILATE AREA TO REMOVE
VAPORS.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.

Handling

Handling and Storage Precautions:IF CONTAM W/ISOCYANATES IS SUSP, DO
NOT RE-SEAL CONTR BECAUSE OF POSS RUPTURE DUE TO PRESS BUILDUP.
ALWAYS SLOWLY VENT CONTR WHEN OPENING (SUPP DATA)
Other Precautions:STORAGE TEMP (MIN/MAX): 65F(18C) TO 75F(24C). AVG
SHELF LIFE: 6 MOS FROM DATE OF MFG. SPECIAL SENSITIVITY
(HEAT/LIGHT/MOISTURE): THIS PROD IS HYGROSCOPIC. CONTRS SHLD BE
TIGHTLY SEALED TO PVNT MOISTUR E CONTAM. DO NOT EXPOSE TO HIGH (ING
5)

Exposure Controls

Respiratory Protection:PROD HAS DEMONSTRATED NO OBSERVABLE EFTS @ RM
TEMP. HOWEVER, IT IS HIGHLY RECOMMENDED THAT A NIOSH/MSHA APPRVD
AIR PURIFYING RESP W/ORGANIC FILTER CARTRIDGES BE WORN. IN ADDN, IN
ANY SPRAY APPLICATN, A SUPPLIED AIR SOURCE MUST BE PROVIDED.
Ventilation:NATURAL/MECH. LOCAL EXHST WILL KEEP TLV BELOW MIN IN MOST
CASES. SPILLS/OTHER EMER MAY REQ MORE FORCEFUL VENT MEANS.
Protective Gloves:CHEM RESIST GLOVES (NATURAL RUBBER/PVA).
Eye Protection:CHEMICAL WORKERS GOGGLES .
Other Protective Equipment:COVER AS MUCH EXPOSED SKIN AS POSS W/APPROP
CLTHG. IF SKIN CREAMS ARE USED, KEEP AREA COVERED BY THE CREAM TO A
(ING 3)
Work Hygienic Practices:NO CONTACT LENSES SHLD BE WORN. WASH CONTAMD
CLTHG BEFORE REUSE.
Supplemental Safety and Health
EXTING MEDIA: HIGH EXPANSION (PROTEINIC) CHEM FOAM, WATER SPRAY FOR LG
FIRES. FIRE FIGHT PROC: PROT EQUIP . BURNING CAN PRDCE CO*X/NO*X.
FIRST AID PROC: TO DRINK TO AN UNCON PERSON OR INDUCE VOM IT IN AN
UNCON PERSON. NOTE TO MD: BASICALLY, TREATMENT IS SYMPTOMATIC.
HNDLG/STOR PREC: TO RELIEVE ANY PRESS BUILDUP.

Chemical Properties

Boiling Pt:B.P. Text:DECOMPOSES
Melt/Freeze Pt:M.P/F.P Text:<32F,<0C
Vapor Pres:NIL
Vapor Density:>1
Spec Gravity:1.07
Solubility in Water:SLIGHTLY SOLUBLE
Appearance and Odor:VISCOUS LIQUID, CLEAR TO AMBER COLOR, SLIGHT
AMMONIA ODOR.

Stability

Stability Indicator/Materials to Avoid:YES
AVOID CONTACT W/ISOCYANATES AND OTHER SUBSTANCES THAT REACT W/HYDROXYL
GROUPS.
Stability Condition to Avoid:NONE SPECIFIED BY MANUFACTURER.
Hazardous Decomposition Products:ALIPHATIC FRAGMENTS, CO, NH*3, CO*2

Disposal

Waste Disposal Methods:WASTE MATL MAY BE INCINERATED OR DISPOSED OF
UNDER LOCAL, STATE AND FEDERAL REGULATIONS CONTROLLING
ENVIRONMENTAL PROTECTION.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.